Pioneer DRM-5004X User Manual page 64

3.11.6 Confirming the SCSI Interface Connection
Software to confirm the SCSI Interface is available on the Pioneer
Bulletin Board System. See Appendix E, Pioneer Technical
Resource Numbers. Use this software to test SCSI viability.
1. Turn the DRM-5004X power on.
2. Confirm normal initialization after turning the power on. The
green LED will be lit steadily. If normal initialization does not
occur the red LED will be lit, refer to Chapter 7, Troubleshooting
If unit still does not initialize, contact Service. See Figure 3-31,
Green and Red Indicator Lights.
3. Power on the computer connected to the DRM-5004X. The
computer should be running DOS 5.0 or above and ANSI.SYS
and ASPI Manager must be included in the Config.Sys:
DEVICE =C:\DOS\ANSI.SYS
DEVICE =C:\xxxx\ASPI.SYS
(xxxx is the name of the directory.)
4. Execute SCSI5ASP.EXE to load the software utility onto the
inspection computer. Press any computer key to access the
main menu from the program start-up. Press the "/" key to call
up the CHANGER menu.
5. Press the "5" to select the SCSI ID for changer control mecha-
nism. The default is 5. If changed, select the correct number.
6. Use the cursor arrow keys to select "INQUIRY" from the
CHANGER menu. Press "ENTER" to execute.
7. Confirm the reply to "INQUIRY" which shows the factory default
condition. If the reply does not match the reply shown below,
contact Service.
08_80_02_02_2A_00_00_00
PIONEER CHANGER DRM-5004X0113
SCSI STATUS: GOOD
NOTE: If SCSI Status reads: "Time Out During Selection
Phase", check that the unit is powered on, the SCSI cable is
attached securely, and the correct SCSI ID has been selected.
8. Exit the SCSI5 program by pressing "Esc", power down the com-
puter and the DRM-5004X and remove the SCSI cable.
NOTE: Testing SCSI communications can be done in different
ways, using the SCSI5ASP.EXE program, or system integrator
software. The end result will be the same.
Pioneer DRM-5004X CD-ROM Jukebox User's Guide TP #120 v .1.0 2/95
Set Up
3
3 - 25