Adding Phones With Bat; Adding Phones With Cisco Unified Communications Manager Administration - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Before You Begin

Adding Phones with BAT

Add a group of phones to the Cisco Unified Communications Manager database by using BAT. This tool
performs batch operations, including registration, on multiple phones. You need the MAC addresses for
each phone before you use BAT.
Table 3-2
Table 3-2
Method
Choose SETTINGS > Model Information >
MAC Address and look at the MAC Address
field.
Remove the battery and look on the back of the
phone.
BAT is included in Cisco Unified Communications Manager 5.0 or later, but it is a plug-in for prior
Note
releases.
For detailed instructions about using BAT, refer to the following documents:
•
•
When using BAT to add Cisco Unified Wireless IP Phones, use the default setting for the phone load.
Note
The phone load name includes symbols (-, _,.) and BAT does not permit symbols in an entry.
Related Topics
•
•
•

Adding Phones with Cisco Unified Communications Manager Administration

Add phones individually by using Cisco Unified Communications Manager Administration. To do so,
obtain the MAC address for each phone before you begin. See the
Unified Communications Manager" section on page 3-2
Perform one of the following after collecting the MAC addresses:
•
•
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
3-4
describes how to determine the MAC address of the wireless IP phone.
Determining the MAC Address of the Phone
For Cisco Unified Communications Manager Release 5.0 and prior releases, refer to Bulk
Administration Tool User Guide for Cisco Unified Communications Manager.
For Cisco Unified Communications Manager Release 6.0(1), 6.1(1), and 7.0(1), refer to Cisco
Unified Communications Manager Bulk Administration Guide.
Adding Phones with Auto-Registration, page 3-3
Adding Phones with Auto-Registration and TAPS, page 3-3
Adding Phones with Cisco Unified Communications Manager Administration, page 3-4
Cisco Unified Communications Manager 5.0, 6.0(1), 6.1(1), or 7.0(1)—Choose Device > Phone and
click Add New.
Cisco Unified Communications Manager 4.x—Choose Device > Add a New Device.
Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
For More Information
See "Viewing Model Information" section on
page 8-7
See the "Installing or Removing the Phone
Battery" section on page 3-8
"Methods for Adding Phones to Cisco
for instructions.
OL-15984-01