Configuring The Wireless Network For Voice; Configuration Tip For Cisco Aironet Aps; Site Survey Verification - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Site Survey Verification

Configuring the Wireless Network for Voice

This section identifies key AP configuration options that are required for optimal voice performance.
This is not a complete list of configuration steps or options for deploying APs such as the Cisco Aironet
APs. For more information about configuring your AP, refer to the appropriate Cisco Aironet AP
installation and configuration guide for your model or the documentation for your AP.
When deploying the Cisco Unified Wireless IP Phone 7925G with World regulatory domain
Note
(CP-7925GW-K9), you must enable the APs for world mode (802.11d). The world model phone gets the
channels and power information from the AP.
To see a list of configuration tasks for the Cisco Aironet AP, controller, and Ethernet switch when setting
up VoIP on the WLAN, see the

Configuration Tip for Cisco Aironet APs

If you are using EAP-FAST, you must increase the EAP request (802.1x) timeout to at least 20 seconds
to ensure that the phone gets the PAC credentials successfully.
To change the request timeout on the controller, follow these steps:
Procedure
Use SSH or Telnet to access the Cisco Unified wireless LAN controller.
Step 1
Step 2 Enter
Enter
Step 3
Enter
Step 4
Site Survey Verification
Before the initial deployment of wireless phones in the WLAN, it is recommended that a site survey is
performed to verify that the APs are providing adequate coverage and that wireless phones can roam
from one AP to another with no audio problems. After the initial deployment, it is a good practice to
perform site surveys at regular intervals to ensure continued coverage and roaming.
From the Cisco Unified Wireless IP Phone 7925G, you can use the Neighbor List utility or Site Survey
utility from the SETTINGS > Status menu.
The Neighbor List utility provides information about the current AP and the closest neighbors tracked
by the phone. For more information see
The Site Survey utility produces a report, written as a temporary HTML file, upon termination of the
survey. This Site Survey Report is accessible from the phone web page for viewing or forwarding to
Cisco TAC for troubleshooting purposes. For more information, see
page
You should use the wireless IP phone and the Aironet Client Utility (ACU) to verify that the signal range
and transmission power provide adequate coverage for roaming phones.
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
2-22
config advanced eap request-timeout 20
save config
to confirm.
y
2-24.
"Configuring a Wireless Network" section on page
Using the Neighbor List Utility, page
Chapter 2 Overview of the VoIP Wireless Network
D-1.
2-23.
Using the Site Survey Utility,
OL-15984-01