Configuring Wireless Lan Settings For The Cisco Unified Wireless Ip Phone 7925G; Cisco Unified Wireless Ip Phone 7925G Web Pages; Network Profile Menu On The Cisco Unified Wireless Ip Phone 7925G; Using A Headset - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7925G
•
Configuring Wireless LAN Settings for the Cisco Unified Wireless IP Phone
7925G
Before the phone can connect to the WLAN, you must configure the network profile for the phone with
the WLAN settings. You can use two methods for setting up the network profiles:
•
•

Cisco Unified Wireless IP Phone 7925G Web Pages

You can access the Cisco Unified Wireless IP Phone 7925G web pages to set up the WLAN settings in
the network profile. For a new phone with the factory default settings, you must use the USB cable to
connect the phone to your PC. For more information and instructions, see
Unified Wireless IP Phone 7925G Web Pages."

Network Profile Menu on the Cisco Unified Wireless IP Phone 7925G

You can use the Settings menu on the phone and access the Network Profiles menu to set up the network
configuration and the WLAN configuration. For more information and instructions, see
"Configuring Settings on the Cisco Unified Wireless IP Phone 7925G."

Using a Headset

Although Cisco Systems performs some internal testing of third-party wired and Bluetooth wireless
headsets for use with the Cisco Unified Wireless IP Phone 7925G, Cisco does not certify or support
products from headset or handset vendors. Because of the inherent environmental and hardware
inconsistencies in the locations where Cisco Unified IP Phones are deployed, there is not a single "best"
solution that is optimal for all environments. Cisco recommends that customers test the headsets that
work best in their environment before deploying a large number of units in their network.
Cisco Systems recommends the use of good quality external devices, like headsets that are screened
against unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of
these devices and their proximity to other devices such as cell phones and two-way radios, some audio
noise may still occur. See
information.
The primary reason that a particular headset would be inappropriate for the Cisco Unified IP Phone is
the potential for an audible hum. This hum can be heard by either the remote party or by both the remote
party and you, the Cisco Unified IP Phone user. Some potential humming or buzzing sounds can be
caused by a range of outside sources, for example, electric lights, being near electric motors, large PC
monitors. In some instances, the mechanics or electronics of various headsets can cause remote parties
to hear an echo of their own voice when they speak to Cisco Unified IP Phone users.
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Using the Power Supply to Charge the Phone Battery, page 3-11
Cisco Unified Wireless IP Phone 7925G Web Pages, page 3-13
Network Profile Menu on the Cisco Unified Wireless IP Phone 7925G, page 3-13
Using External Devices with Cisco Unified IP Phones, page 3-15
Installing the Cisco Unified Wireless IP Phone 7925G
Chapter 4, "Using the Cisco
Chapter 5,
for more
3-13