Overview Of Configuring And Installing The Cisco Unified Wireless Ip Phone 7925G; Manager - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Overview of Configuring and Installing the Cisco Unified Wireless IP Phone 7925G

If the phone is configured for encryption, the user can barge into an authenticated or non-secure call from
the encrypted phone. After the barge occurs, Cisco Unified Communications Manager classifies the call
as non-secure.
If the phone is configured for encryption, the user can barge into an encrypted call, and the phone
indicates that the call is encrypted.
A user can barge into an authenticated call, even if the phone that is used to barge is non-secure. The
authentication icon continues to display on the authenticated phones in the call, even if the initiator's
phone does not support security.
Overview of Configuring and Installing the Cisco Unified
Wireless IP Phone 7925G
When deploying a new IP telephony system, system administrators and network administrators must
complete several tasks to prepare the network for IP telephony service. For information and a checklist
for setting up and configuring a complete Cisco IP telephony network, refer to the "System
Configuration Overview" chapter in the Cisco Unified Communications Manager System Guide.
After you have set up the IP telephony system and configured system-wide features in Cisco Unified
Communications Manager Administration, you can add IP phones to the system. To add
wireless IP phones to the IP network, system administrators should conduct a site survey to determine
strategic locations for access points (APs) to ensure good wireless voice coverage. For detailed
information about a voice over WLAN deployment, refer to the
Guide.
The following topics provide an overview of procedures for adding Cisco Unified IP Phones to your
network:
•
•
Configuring the Cisco Unified Wireless IP Phone 7925G in Cisco Unified
Communications Manager
To add phones to the Cisco Unified Communications Manager Administration, you can use:
•
•
•
•
For more information about these choices, see the
Unified Communications Manager" section on page
For general information about configuring phones in Cisco Unified Communications Manager, refer to
the "Cisco Unified IP Phone" chapter in the Cisco Unified Communications Manager System Guide.
For a checklist of tasks for configuring the phone in Cisco Unified Communications Manager, see the
"Configuring the Cisco Unified Wireless IP Phone 7925G in Cisco Unified Communications Manager"
section on page
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
1-14
Configuring the Cisco Unified Wireless IP Phone 7925G in Cisco Unified Communications
Manager, page 1-14
Installing the Cisco Unified Wireless IP Phone 7925G, page 1-15
Auto-registration
Cisco Unified Communications Manager Administration
Bulk Administration Tool (BAT)
BAT and the Tool for Auto-Registered Phones Support (TAPS)
D-4.
Chapter 1 Overview of the Cisco Unified Wireless IP Phone 7925G
Cisco Enterprise Mobility 3.0 Design
"Methods for Adding Phones to Cisco
3-2.
OL-15984-01