Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual page 87

Chapter 4 Using the Cisco Unified Wireless IP Phone 7925G Web Pages
Table 4-3
Item
IP Network Configuration
Obtain IP address and
DNS servers
automatically
Use the following IP
address and DNS
servers
TFTP
Obtain TFTP Servers
Automatically
Use the following
TFTP servers
Table 4-4
TSPEC Settings
Minimum PHY Rate
Surplus Bandwidth
802.11G Power Settings
Channel
Status
MaxTxPower
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Basic Network Profile Settings (continued)
Description
Gets the IP address and DNS servers
automatically.
Disables DHCP and uses these static settings:
• IP Address
Subnet Mask
•
• Default Router
Primary DNS
•
Secondary DNS
•
Domain Name
•
Enables automatic assignment of TFTP servers
Assigns static TFTP server IP addresses to:
TFTP Server 1
•
TFTP Server 2
•
Advanced Network Profile Settings
Minimum data rate that outbound traffic uses.
Modify this setting when Call Admission
Control (CAC) is enabled.
Cisco APs support only PHY rates of 6,
Note
11, 12, or 24. The default is 12. If you
use an access point that using 802.11b,
the PHY rate must be configured to the
supported rate.
Excess bandwidth beyond application
requirements
Assigns the channels
Enabled—Identifies enabled channels in WLAN
to improve scanning for the phone.
Sets the maximum transmit power for the phone
Configuring Network Profiles
For More Information, See...
Configuring IP Network
Settings, page 4-23
Configuring the Alternate
TFTP Server, page 4-24
Configuring Advanced
Network Profile
Settings, page 4-25
Configuring Advanced
Network Profile
Settings, page 4-25
4-11