Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual page 215

Chapter 10 Troubleshooting the Cisco Unified Wireless IP Phone 7925G
To erase the local configuration, follow these steps:
Procedure
Choose SETTINGS > Phone Settings.
Step 1
Press **2 on the keypad.
Step 2
The phone briefly displays "Start factory reset now?"
Press the Yes softkey. All settings are deleted.
Step 3
The phone cycles through normal startup procedures.
Or press No to cancel the reset.
Press SETTINGS > Network Profiles to reconfigure the network settings for your WLAN.
Step 4
Erasing the local configuration removes network profiles that are set up for the Cisco Unified Wireless
Caution
IP Phone to access the WLAN. You must reconfigure the network settings after performing the reset to
enable the phone to access the WLAN.
Related Topics
Resolving Startup and Connectivity Problems, page 10-1
•
Resolving Voice Quality and Roaming, page 10-8
•
General Troubleshooting Information, page 10-14
•
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Erasing the Local Configuration
10-19