Auto-Registering Your Phone Using Taps - Cisco 7910 - IP Phone VoIP Getting Started Manual

Auto-Registering Your Phone Using TAPS

Auto-Registering Your Phone Using TAPS
Note
Step 1
Step 2
Step 3
Step 4
Getting Started with the Cisco IP Phone 7910 Series
2-6
Your administrator may ask you to auto-register your Cisco IP Phone using TAPS,
the Tool for Auto-Registered Phones Support. TAPS might be used either for a
new phone or to replace an existing phone.
Only follow this procedure if your phone administrator asks you to.
Procedure
If the phone is not already installed, see the
to the Network" section on page 2-3
available.
After you plug the phone into a port, the phone automatically registers and
displays a number.
Dial the TAPS extension provided by your system administrator.
Follow the voice prompts to enter your personal extension number (provided by
your system administrator), followed by #. Listen to the voice prompts to
determine if you need to enter the entire number, including area code.
Hang up the phone.
The phone resets and displays your extension number.
Chapter 2 Installing the Cisco IP Phone 7910 Series
"Installing the Phone and Connecting
for instructions on installing the phone
78-11443-02