Redialing The Last Number Dialed; Parking A Call - Cisco 7910 - IP Phone VoIP Getting Started Manual

Making Telephone Calls

Redialing the Last Number Dialed

Parking a Call

Step 1
Step 2
Step 3
Getting Started with the Cisco IP Phone 7910 Series
3-8
To redial the most recently dialed number, lift the handset and press the redial
button.
Redial is an optional feature configured by your system administrator. Although
your phone supports this feature by default, your system administrator might have
removed this feature from your phone.
You can store or "park" a call at a specified number and then use any other phone
(for example, a phone in someone else's office or in a conference room) to retrieve
the call.
Call Park is an optional feature configured by your system administrator; your
phone does not support this feature by default. Call Park is only available if your
system administrator configured your phone to support it.
During an active call, press the park button.
The display shows the number to which the call is parked.
Make a note of the Call Park number and then hang up. The call is now parked at
that number, allowing you to retrieve it from another phone.
Note You have a reasonable but limited amount of time to retrieve
the parked call before it disconnects. See your system
administrator for more information.
To retrieve the parked call from any phone in the Cisco CallManager system, dial
the Call Park number at which the call was parked.
Chapter 3 Using the Cisco IP Phone 7910 Series
78-11443-02