Table of Contents
Advertisement
18
Mounting an internal Fibre Channel drive
You can mount the internal Viper 200 either horizontally or
vertically with the drives left side facing up (see Figure 9). If a
drive is mounted vertically, the side of the drive should be
within 5 degrees of horizontal. If a drive is mounted
horizontally, the base of the drive must be within 15 degrees
of horizontal and the PCB side of the drive must face down.
YES
Figure 9. Acceptable mounting orientations for the
internal Viper 200
Mount the drive in a 5.25-inch, full-height drive bay and
secure it using two M3.0 metric screws on each side of the
drive. The locations of screw holes are shown in Figure 10 on
the following page. Do not use screws longer than 5 mm or
you may damage the drive.
Viper 200 Installation Manual
YES
NO
NO
Advertisement
Table of Contents
