Viper 200 Installation Manual
Operating and maintaining the Viper 200
This chapter describes how to use your Viper 200. It explains
the meaning of the LEDs on the front of the drive and
describes how to use and care for the Ultrium tape drive and
Ultrium cartridges.
Front Panel Display
There are several front panels available for the Viper 200.
Different panels may be used, depending on whether the
drive will be used in an automation environment, such as a
tape library, or as a stand-alone drive. A generalized view of
the front-panel display is shown in Figure 16.
Figure 16. Generic front panel display for Viper 200
All Viper 200 drives have a Load/Unload button on the front
panel. All drives also have four LEDs on the front panel. The
functions, colors and status of the lights are summarized in
the following paragraphs.
•
Tape Cartridge Slot
Status
Error
LED
LED
(Amber)
(Orange)
Status LED (amber) – If the Status LED stays on
continuously, the drive needs to be cleaned. Other
changes in drive or cartridge status are indicated by
Power
LED
(Green)
Drive
LED
(Green)
25
Tape
Load/Unload
Button