Seagate STU62001LW-S Installation Manual page 38

36
Case 2. Cartridge is loaded and seated and tape is threaded
Follow these steps if the cartridge is loaded and seated, and
the tape is entirely or partially threaded into the drive. You will
need a small, flat-blade screwdriver and a 1.5-mm hex
wrench. Figure 20 shows key components of the drive
mechanism that are referred to in the text below.
Note. Do not touch any part of the drive mechanism except
Worm gear
Head assembly
Figure 20. Diagram of Viper 200 showing key
components used in manual cartridge removal (no tape
cartridge in drive)
for the components specified in the instructions. Be
especially careful not to touch the tape head
assembly. The MR elements in this assembly are
highly susceptible to damage from static electricity.
Viper 200 Installation Manual
Lead screw
Take-up reel
and hub
Tape grabber
Load arm
Slot in
drive chassis