Table of Contents
Advertisement
Viper 200 Installation Manual
Installing an external Viper 200
The external Viper 200 drives (STU62001LW and
ST62001WD) are compact external units that connect to the
host computer through an external SCSI port. Installing the
external drive involves the three simple steps: configuring the
drive, attaching the SCSI cable(s), and attaching the power
cord.
Configuring an external drive
Setting the SCSI ID
Make sure that the drive is turned off. Then set the SCSI ID
for the drive using the push-button switch on the back of the
external drive, as shown in Figure 14. The change will take
effect when you turn the drive back on.
SCSI ID selector
On/Off switch
AC Power
connector
Figure 14. Back of external Viper 200 showing switches
and connectors
+
–
23
68-pin wide SCSI
connectors
Advertisement
Table of Contents
