Seagate STU62001LW-S Installation Manual page 36

34
4. Remove the drive from its operating environment.
5. Place the drive on a workbench with proper ESD
6. Remove the top cover of the drive by removing eight
7. Inspect the drive to determine which procedure you
Figure 18. Diagram of Viper 200 showing leader pin
inside LTO cartridge (tape not threaded on take-up hub)
Case 1: Cartridge is loaded and seated
If the cartridge is loaded and seated and the leader pin is still
inside the cartridge, follow these steps to remove the
cartridge. To remove the cartridge you will need a small, flat-
blade screwdriver
1. Verify that the leader pin is still inside the cartridge as
grounding: attach a wrist strap to the bench and the other
end to your wrist.
screws. (You will need a 1.5-mm hex driver).
Note. Do NOT remove the front bezel or the bottom
cover from the drive.
should follow:
•
Case 1: The cartridge is loaded and the leader pin is
still in the cartridge (see Figure 18). Follow the
procedure on page 34.
•
Case 2: The cartridge is loaded and seated, and the
tape is threaded or partially threaded on the take-up
hub. Follow the procedure on page 36.
shown in Figure 18 on the previous page. If the leader pin
Viper 200 Installation Manual