Table of Contents
Advertisement
12
Cables and connectors (internal HVD or LVD drive)
Connecting the SCSI interface cable
Viper 200 drives are designed to be used with an Ultra2 SCSI
interface with a 68-pin HVD or LVD SCSI connector. Before
attaching or detaching cables, turn off all power to the drive
and computer. Attach the interface cable to the 68-pin SCSI
interface connector on the back of the drive (see Figure 4).
Serial Interface
connector (pins
on 2-mm centers)
Figure 4. Rear view of the Viper 200 internal drive
Install an HVD drive only in an HVD environment and an LVD
drive only in an LVD environment. Do not mix HVD and LVD
devices. Look at the label above the drive's SCSI connector
to determine if the drive is an HVD or an LVD model:
LVD label:
Caution.
Drive-
configuration
jumper pins
HVD label:
Plugging an HVD drive into an LVD bus or vice
versa will make the entire bus non-functional and
may permanently damage the drive or other
SCSI devices on the bus.
Viper 200 Installation Manual
5 / 12 Volt
power
connector
FC label:
Fibre Channel
68-pin
SCSI
connector
Advertisement
Table of Contents
