Seagate STU62001LW-S Installation Manual page 40

38
4. Insert the 1.5-mm hex wrench through the hole in the
Caution: If you turn the hex wrench quickly or unevenly, you
Figure 22. Diagram of underside of Viper 200 showing
supply motor access hole
5. When all of the tape has been spooled off of the take-up
6. Rotate the hub to align the slot in the hub with the slot on
7. Set the drive on its left side. Rotate the load arm until the
bottom plate shown in Figure 22. Turn the hex wrench
clockwise slowly and smoothly to rewind the tape into the
cartridge. This may take some time.
may create a tape loop, which could cause tape
contamination.
reel, turn the drive right side up.
the drive chassis (see Figure 20).
tape grabber clears the hub.
Viper 200 Installation Manual