Table of Contents
Advertisement
8
•
Configuring an internal HVD or LVD drive
Before you install the tape drive in your computer, you may
need to configure the drive's SCSI ID and other drive
features. Jumpers located on the back of the drive (near the
left edge of the drive) are used to configure the SCSI ID and
to enable termination power.
Default settings
The default drive settings for the Viper 200 are listed below:
•
•
If these default settings are appropriate for your needs, skip
ahead to "Mounting an internal HVD or LVD drive" on page
10.
Jumper settings
Configuration jumpers on the back of the drive control the
drive's SCSI ID and SCSI terminator power. The jumpers can
also be used for remote SCSI address selection. Figure 1 on
the following page shows the locations of the jumper blocks
for the internal Viper 200.
Always lay the drive either on top of the antistatic bag or
place it inside of the bag to reduce the chance of damage
from static discharge.
SCSI ID: 6
Termination Power: disabled.
Viper 200 Installation Manual
Advertisement
Table of Contents
