Installation
Mounting the Drive
41.3 mm
(1.63 in)
28.3 mm
(1.11 in)
2 Places
35.0 mm
(1.38 in)
2 Places
M3.0 X
4 Deep Min.
10 Places
6.0 mm
(0.24 in)
2 Places
41.2 mm
(1.62 in)
Side
Figure 13. Mounting Hole Locations (Internal Drive without Rails)
Product Manual
You can install the internal drives in three different orientations: one horizontal (eject
button right) and two vertical (eject button up or eject button down).
The internal drive chassis contains threaded mounting holes for M3.0 metric screws.
The maximum length for the M3.0 metric screws is 4 mm. Four are located on the
bottom and five are on each side of the frame. See Figure 13 for details.
8.0 mm
(0.31 in)
2 Places
5.0 mm
(0.20 in)
2 Places
30.0 mm
(1.18 in)
2 Places
152 mm
(5.98 in)
2 Places
60.0 mm
(2.36 in)
2 Places
21.0 mm
(0.83 in)
2 Places
101.6 mm
(4.00 in)
3.8 mm
(0.15 in)
2 Places
94.0 mm
(3.70 in)
45.0 mm
(1.77 in)
70.0 mm
(2.76 in)
31.0 mm
(1.22 in)
104.1 mm
(4.10 in)
Bottom
Chapter 3
M3.0 X
4 Deep Min.
4 Places
Page 27