Seagate STU62001LW-S Installation Manual page 52

50
2. From the next menu choose "Install a SCSI tape drive".
3. When prompted enter the SCSI adapter string. You may
4. Enter the number of the SCSI host adapter the drive is
5. Enter the number of the SCSI bus the drive is attached to
6. Enter the SCSI id of the drive as shown by the jumpers
7. Enter the number zero (0) for the LUN of the device.
8. When prompted to "Update the SCSI configuration? (y/n)"
9. Enter "SEAGATE" when prompted for Vendor
10. Enter the number three (3) when prompted to enter the
11. Enter the number two (2) when prompted to enter the
12. When prompted choose the Generic SCSI-1/SCSI-2 tape
13. When the process takes you back to the two Main Menu
14. When asked to create a new kernel enter, "yes". When
Notes: Not all of the SCO 'tape' commands will operate or be
want to use the h option to view the list of supported
SCSI adapters.
attached to. If only one SCSI adapter exists then enter
the number zero (0).
on the adapter. Refer to the SCSI adapter documentation
(for many adapters this will be zero (0).
on the rear of the drive (see Figure 1).
enter y.
Identification string (no quote marks).
SCSI version that the tape drive conforms to.
Response Data Format the tape drive uses.
drive option.
screens press 'q'.
asked if you want the new kernel to boot by default press
'y'. When asked if you want the kernel environment to be
rebuilt press 'y'. When finished reboot the system.
applicable to the Seagate Viper 200 drive (execute the
command 'man tape' for the specifics on how the tape
command works). The following tape commands are
Viper 200 Installation Manual