Seagate DAT Drive Installation Manual—English
Mounting an internal DAT drive
You can install your Seagate internal DAT drive horizontally
or vertically (on its side).
Mounting the drive in a 3.5-inch drive bay
To mount the drive in a 3.5-inch drive bay, mount the drive
using two M3.0 metric screws on each side of the drive. Do
not use screws longer than 4 mm or you may damage the
drive. As shown in Figure 4, the 3.5-inch drive has four screw
holes on the bottom and five on each side.
Figure 4
Mounting holes for internal DAT drive in 3.5-inch
configuration (no mounting brackets)
41.3 mm
(1.63 in)
28.3 mm
(1.11 in)
2 PLACES
35.0 mm
(1.38 in)
2 PLACES
M3.0 X
4 DEEP MIN.
10 PLACES
6 mm
(.24 in)
2 PLACES
41.2 mm
(1.62 in)
Side View
3.8 mm
8.0 mm
(.15 in)
(.31 in)
2 PLACES
2 PLACES
5.0 mm
(.20 in)
2 PLACES
30.0 mm
(1.18 in)
2 PLACES
152 mm
(5.98 in)
60.0 mm
(2.36 in)
2 PLACES
21.0 mm
(.83 in)
2 PLACES
Bottom View
A-13
101.6 mm
(4.00 in)
94.0 mm
(3.70 in)
45.0 mm
(1.77 in)
M3.0 X
4 DEEP MIN.
4 PLACES
70.0 mm
(2.76 in)
31.0 mm
(1.22 in)
104.1 mm
(4.10 in)