Table of Contents
Advertisement
Viper 200 Installation Manual
Configuring for HP-UX 11.0
Finding current hardware/driver configuration
To find currently installed SCSI controllers and devices the
ioscan
ioscan –f
devices and their device names.
Attaching the Seagate Viper 200
Choose a SCSI address that does not conflict with any
already attached SCSI devices on your SCSI controller. See
figure 1 for jumper installation for the Viper 200. Attach the
Viper 200 LTO drive and apply power to the Viper 200 and
the host system. After the boot process is complete and you
have logged in as superuser issue the command:
ioscan –C tape –f.
You should see output similar to:
Class
I
H/W Path
Tape
7
8/12.6.0
From the root directory and as superuser issue the
command:
/sbin/insf –C tape.
Now issue the command:
/sbin/mksf –d stape –H x/x.x.x –I y –c 1
–n –u /dev/rmt/zcnb
Where
is the data under
y
device identifier number. You can execute an
for the /dev/rmt directory to choose an identifier number
which has not already been used. Also, you can choose a
unique device name such as
which device name will enable data compression during
write. Please refer to the man pages for mksf to review
command can be used. The syntax would be
. This command will list all of the system
Driver
S/W State
stape
Claimed
is the data under
x
I
H/W type
Device
H/W Path
from the ioscan and
to more easily remember
cnb
Description
SEAGATE ULTRIUM
from the ioscan
is tape
z
command
ls
55
,
Advertisement
Table of Contents
