Seagate STU62001LW-S Installation Manual page 42

40
Figure 24. Diagram of Viper 200 showing worm gear
13. Continue turning the worm gear until the cartridge is
14. After you have removed the cartridge, put the top cover
15. Return the drive to Seagate.
Caution. Do NOT use the drive after you have removed a
Note. Any tape cartridge removed using this procedure
If you have any questions on this process, contact Seagate
Technical Support for Tape Products (see Section 8 for
contact numbers).
sticking out of the unit approximately 17 mm (0.66").
Then carefully pull the cartridge out by hand.
back on the drive; then replace and tighten the screws.
cartridge. The drive must be returned to Seagate
for servicing.
should be retensioned before it is used for reading or
writing data.
Viper 200 Installation Manual