Seagate STU62001LW-S Installation Manual page 41

Viper 200 Installation Manual
Caution. Be especially careful not to touch the tape head
8. Take up the slack tape again using the 1.5-mm hex
9. Carefully push the grabber in toward the cartridge, as
Figure 23. Diagram of underside of Viper 200 showing
tape grabber near cartridge
10. When the leader pin and the tape grabber reach the
11. Using a flat-blade screwdriver, pivot the white lower track
11. After the grabber has released the leader pin, pull the
12. Use a flat-blade screwdriver to turn the worm gear
assembly. The MR elements in this assembly are
highly susceptible to damage from static
electricity.
wrench, as described in step 4 above.
shown in Figure 23.
cartridge, gently push the grabber toward the front of the
cartridge. Use the grabber to push the leader pin gently
into the cartridge until it seats in place (you should hear a
click).
toward the drive bezel to disengage the leader pin.
loader arm out of the way.
counter clockwise (to the left). Figure 24 shows the
location of the worm gear. This will gradually raise the
cartridge elevator and cause the cartridge to slide
partially out of the drive.
39