Seagate STU62001LW-S Installation Manual page 28

26
•
•
•
The following table summarizes all the "blink codes" used by
the Viper 200.
Drive Condition
Cleaning Request
Write Protected
Prevent Media Removal Mode
Active
Hardware or Firmware Error
Positioning – Loading, Unloading,
Rewinding, Spacing or Locating
Tape Active – Writing, Reading or
Verifying
SCSI Active
Manual Intervention Required
Power On Self Test (POST) Failure
Excessive Rewrites or Read C2
errors
Cleaning Cartridge Present
Cleaning Cartridge at EOT
SCSI bus reset
Servo Initialization
various blinking patterns, which are described in the table
below.
Error LED (orange) – The Error LED blinks if the drive
has experienced a non-recoverable error.
Drive LED (green) – The Drive LED is lit whenever a
tape is loaded and ready for use. The Drive LED blinks
whenever a tape is loaded and moving.
Power LED (green) – The Power LED blinks during drive
power-up and Power-on Self Test (POST). If there is an
error during the POST, the Power LED remains on (not
blinking), along with the Status LED. During normal
operation, the Power LED remains on (not blinking).
Viper 200 Installation Manual
Status LED Error LED
(Amber) (Orange)
ON
1/4 sec ON
1/4 sec OFF
1/2 sec ON
1/8 sec OFF
1/8 sec ON
1/8 sec OFF
1/8 sec ON 1/8 sec ON
1/8 sec OFF 1/8 sec OFF
ON 1/2 sec ON
1/2 sec OFF
1/4 sec ON
1/4 sec OFF
ON
1/8 sec ON
1/8 sec OFF
1/4 sec ON
1/8 sec OFF
1/2 sec ON
Drive LED
(Green)
ON
continuously
1/2 sec ON
1/8 sec OFF
1/4 sec ON
1/8 sec OFF
1/8 sec ON
1/8 sec OFF
ON
ON
1/4 sec ON
1/8 sec OFF
1/2 sec ON