Using Ultrium Cartridges - Seagate STU62001LW-S Installation Manual

Viper 200 Installation Manual
Drive Condition
Power On Self Test (POST)
In Progress
Cleaning Failure
Microcode Download
Microcode Download Error

Using Ultrium Cartridges

Loading a cartridge
To load an Ultrium cartridge into the Viper 200, place the
cartridge in the slot and then push it to the detent. Then:
•
•
•
After you insert the cartridge, there will be a brief delay while
the drive identifies the cartridge type and state and moves the
tape to the data area.
Unloading a cartridge
To unload an Ultrium cartridge from the Viper 200, either:
•
•
Caution.
Continue to push the cartridge the rest of the way into the
drive; or
Press the load/unload button on the front of the drive to
seat the cartridge; or
Use a library or host command to finish loading the tape.
Push the load/unload button on the front of the drive; or
Use a library or host command to unload the tape.
Several seconds may elapse between the time
you press the eject button and the time the
cartridge is ejected. Do not power down the tape
drive or the host computer until the Viper 200 has
completely ejected the cartridge.
Status LED Error LED
(Amber) (Orange)
1/2 sec OFF
1/4 sec ON 1/4 sec ON
1/4 sec OFF 1/4 sec OFF
1/8 sec ON 1/8 sec ON
1/8 sec OFF 1/8 sec OFF
1/8 sec ON 1/4 sec ON
1/8 sec OFF 1/4 sec OFF
1/8 sec ON 1/8 sec ON
1/8 sec OFF 1/8 sec OFF
27
Drive LED
(Green)
1/2 sec OFF
1/4 sec ON
1/4 sec OFF
ON
1/8 sec ON
1/8 sec OFF
1/8 sec ON
1/8 sec OFF