Table of Contents
Advertisement
10
Mounting an internal HVD or LVD drive
You can mount the internal Viper 200 either horizontally or
vertically with the drives left side facing up (see Figure 2). If a
drive is mounted vertically, the left side of the drive must face
up and the side of the drive should be within 5 degrees of
horizontal. If a drive is mounted horizontally, the base of the
drive must be within 15 degrees of horizontal and the PCB
side of the drive must face down.
YES
Figure 2. Acceptable mounting orientations for the
internal Viper 200
Mount the drive in a 5.25-inch, full-height drive bay and
secure it using two M3.0 metric screws on each side of the
drive. The locations of screw holes are shown in Figure 3 on
the following page. Do not use screws longer than 5 mm or
you may damage the drive.
Viper 200 Installation Manual
YES
NO
NO
Advertisement
Table of Contents
