Digital Control DIGITRAK FALCON F5+ User Manual page 70

STEP 9 OF 10
Toggle to the lowest band, click to select, then click again to assign it as the
Down band.
Before assigning the Down band, you must pair the Up band to
the transmitter. Otherwise rescanning will erase the current
frequencies.
STEP 10 OF 10
Select Pair to pair and select
power level for the Down
band before proceeding to
calibration as you normally
would when pairing both
bands at one location.
GLOSSARY DEFINITIONS
*INTERFERENCE
Your locator can only detect active interference, not passive interference, such as rebar.
Lower frequency bands tend to perform better around passive interference. Middle
bands can perform better in deeper bores and may have longer Target Steering
capability. High bands have slightly less signal strength, but tend to offer better
performance around active interference such as power lines.
*BAND WITH THE LEAST NOISE
DIGITAL CONTROL, INC
DIGITRAK FALCON F5+
DCI DigiGuide
USER MANUAL
11.04.2023
70