Editing An Existing Registration Sequence - Yamaha Electone STAGEA ELS-01C Owner's Manual

9
176 ELS-01/01C/01X Owner's Manual
4
Press the DATA [SET] button in the display.
The Registration number appears in the display (in the timing order), indicating
that the Registration is entered. Up to 140 Registrations can be entered.
If some Registration numbers are entered to the same Bar/Beat/Clock, the last
entered one takes priority.
5
Repeat steps #2 through #4 above to set the Registration
Sequence.
Entering Next Regist:
When you program the Next Regist function in Registration Sequence, the next
registration data in current song can be loaded automatically just by playing the
rhythm sequence.
1
Using the
dial, set the Bar/Beat/Clock position at which you want to enter
the Next Regist (1 beat = 96 clock).
2
Press the NEXT REGIST [INSERT] button in the display.
The Next Regist mark
indicating that the Next Regist is entered.
Next Regist Loading Time
• Loading Next Regist may take a few seconds (the time may differ depending on
the size of the data to be loaded).
• When using a floppy disk instead of SmartMedia card, the loading time will be
longer than when using SmartMedia.
• Next Registration data can be loaded by two ways: using right footswitch and
programming Next Regist in the Registration Sequence. Loading time is the same
regardless of which way you load the Next Registration data.

Editing an Existing Registration Sequence

You can move or delete the entered Registration Sequence (Registration number or
Next Regist data) from the sequence.
To move an entry:
1
Using the POSITION buttons, move the cursor and select the data
(Registration number or Next Regist) you want to move.
2
Change the position by pressing the Bar/Beat/Clock buttons in
the display.
buttons in the display or the Data Control
appears at the timing point you set in step #1,