Yamaha Electone STAGEA ELS-01C Owner's Manual page 40

NOTE
Parameters that are available
only on the ELS-01C/01X are
indicated by a dark frame
and background in their
display controls.
4
Reference Page
Solo function (page 27)
40 ELS-01/01C/01X Owner's Manual
3
PITCH
Controls pitch according to the play style of Horizontal Touch or After Touch.
On some Voices in the Lead Voice 2 section, not only pitch but also timbre may be
affected.
3
HORIZONTAL touch (ELS-01C/01X)
-1
Controls the pitch by holding down the key and moving it laterally (wiggling
your finger from side to side). The faster you move the key laterally, the faster
and greater the pitch change becomes, within a range of +/- one octave. You can
use this function in combination with Touch Tone described above to add
expressiveness to your performance.
Higher settings result in a wider pitch change. The minimum setting produces
no effect. This function is not available on the Pedalboard.
Range: 0 – 14
3
AFTER touch
-2
Controls the pitch according to the pressure you apply to the keys after playing
them.
The minimum setting produces no effect at all. Higher (positive) settings make
the pitch higher according to the pressure and lower (negative) settings make the
pitch lower. The setting of +14 or -14 results in the widest pitch change.
Range: -14 – +14
4
FEET
Determines the octave setting of the Voice, letting you use the Voice over a wide
register. There are three settings: 4', 8' and 16' (4' is highest and 16' is lowest). A 2'
setting is added to the Pedal Voice sections. PRESET is the original (factory) setting.
5
REVERB
Determines the amount of reverb applied to each Voice section. When the panel
REVERB control is set to the minimum, the setting here will have no effect.
See page 43 for details.
6
VOLUME
Fine adjustment of the Voice volume. See page 25 for more information.
7
PRIORITY (only for the Lead Voice 2)
Determines the mode of Lead Voice 2, Last or Top.
LAST: Only the last played key is sounded when two or more keys are played
simultaneously.
TOP: Only the highest note is sounded when two or more keys are played
simultaneously. When the Solo mode is on, Lead Voice 2 sounds according to
Last mode, regardless of the setting made here.
8
POLY (only for Pedal Voices)
Allows you to switch the pedal polyphonic mode on or off. Setting POLY to on
switches the normally monophonic pedal Voices to polyphonic play. This makes it
possible to play the Pedalboard in various expressive ways, such as playing legato or
playing intervals and chords.
Keep in mind that you cannot exceed the total maximum polyphony: 14 notes for all
sections, Upper, Lower and Pedal.