HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 74

Installing a Stand-alone Server in a Cabinet
WARNING
Step 2. Remove the stand alone server from it's packing materials, if not already unpacked.
Step 3. Refer to the A-400/A-500 Server Slide Rail Installation instructions, for both server and cabinet
rail installation instructions.
Installing Bezel End Caps
Each server is shipped with two metal brackets and two plastic end caps that are designed to be attached to a
stand alone server if it is to be mounted in a cabinet. Locate these items and have them available for
installation. The following diagram shows the location of bezel end caps and brackets on a racked server.
ccrr001
Callout #
1
82
If anti-tip stabilizers or ballast are not installed or are improperly installed
on the cabinet, it can tip. Failure to follow this precaution can cause
personal injury or death and can damage equipment.
3
2
1
Server-to-cabinet attachment screws
1 2
Item
3
Chapter