HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 131

System Console Configuration
The following describes the steps required to configure the HP C1099A or 700/96 terminal for VT-100 mode
for operation with an rp24xx server.
C1099A VT-100 Mode Configuration.
The following procedure outlines the steps to configure the C1099A terminal for VT-100 operation.
To access the Setup menu in HPTerm emulation:
1. Press the key to display the terminal local function labels, then Press
F10
You are now in the Quick (
2. Select the VT100 emulation by using the space bar to navigate through the available options.
3. Press the key to save selected setup parameters and to exit the Setup menu.
ESC
4. Press the key when the blinking prompt
Y
Save all? (Y/N)
appears in the upper right corner of the menu to save the settings in non-volatile memory.
If you enter
NOTE
Save all? (Y/N)
prompt appears, the changes will take effect, but will be lost if the terminal is reset or
powered off.
HP700 VT-100 Mode Configuration
The following procedure outlines the steps to configure the HP700 series terminal for VT-100 operation.
NOTE You may use either the arrow keys or the tab key to move between the setting options on the
screen.
Be sure to save any configuration changes you make before proceeding to a new menu.
1. Press
[User System]
2. Press function key.
[config keys]
3. Press
[terminal config]
4. Move to Terminal ID and enter "vt100".
5. Move to TermMode and, using the
6. Save the configuration.
7. Press the
[config keys]
8. Press the
[ansi config]
Chapter
) menu.
F1
when the
N
key.
[f8]
function key.
[f5]
and
[Prev]
[f1]
function key.
[f8]
function key.
[f6]
keys, select "EM100".
[Next]
System Console Configuration
(config keys).
F8
139