HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 201
Hardware manual - rp24xx, customer viewable
Hide thumbs
Also See for A4500A - VMEbus Single Board Computer 744 Motherboard:
- Manual (114 pages) ,
- Programmer's manual (109 pages) ,
- Safety and regulatory information manual (24 pages)
Table of Contents
Advertisement
Insert the Server into the Rack
Insert the Server into the Rack
rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers
mounted in an HP-supported rack is covered in this section.
To return the server into the rack, perform the following steps:
Step 1. Push and hold each rail clip in to unlock the rail from the fully extended position. Slowly push
server chassis completely into the rack.
Step 2. Replace the four T-25 screws on each side of the server that fasten it to the rack.
Step 3. Attach the front Bezel.
The following graphic shows the server extended and indicates the rail clip location.
ccrr014
297
Chapter
- Quick Links:
- Server External Connections
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the A4500A - VMEbus Single Board Computer 744 Motherboard and is the answer not in the manual?
Questions and answers