HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 179

PCI I/O Card Removal
PCI slots 2, 3, and 4 are located in the I/O Card Cage, which must be taken out of the chassis prior to
removing these cards. PCI slot 1 supports a short PCI I/O card attached to the I/O Backplane and is located
outside of the card cage If a Secure Web Console card was ordered as part of the system, it may be located in
this slot and must be removed before taking the I/O Card Cage out of the chassis.
CAUTION Ensure that the system is shut down and power removed from the server before attempting
removal or replacement of a component. Always use an antistatic wrist strap and mat when
working on the server.
Remove PCI I/O cards as follows:
• To remove PCI I/O card 1:
a. Remove the screw that fastens the connector to the inside bulkhead.
b. Pull the I/O card out of its slot on the outside I/O Backplane.
NOTE If you are removing the Secure Web Console card in the slot 1 position, ensure that the 5v
power plug is removed from the power outlet (located on the Guardian Service Processor
(GSP), front right side).
• To remove PCI I/O cards 2, 3, and 4:
a. Take the I/O card cage out of the server.
b. Grasp the edge of the I/O card and pull it out of its slot in the card cage.
The following graphic shows an exploded view of the I/O card cage with I/O cards.
Chapter
PCI I/O Card Removal
251