HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 105

Configuring the Guardian Service Processor (GSP)
The Guardian Service Processor (GSP) is resident in the system to allow the system administrator to monitor
and perform administrative functions locally on the system console, or at a console in another area. This
section provides configuration procedures that will:
• Configure the GSP Local Area Network (LAN) port
• Add or delete GSP users (maximum of 20)
• Change the default GSP configuration.
Configuring the GSP LAN Port
Perform LAN configuration from the system's local port (either console or the HP secure web console).
NOTE The GSP LAN port is different from the System LAN. It will need a separate:
• 10BaseT LAN connection
• Subnet mask
• Gateway address
• Hostname (to be used when messages from the console are logged or printed)
To configure the GSP LAN port, perform the following steps:
Step 1. To select the GSP, enter:
Step 2. At the GSP prompt, enter the following LAN Configuration (lc) command:
GSP> lc
The lc comrp24xxmand will start a series of prompts. Respond to each prompt with the appropriate
information.
Adding Users
The GSP stores access information for a maximum of 20 users (one administrator and 19 operators). By
design, the first user entered into the GSP becomes the GSP administrator. Only the GSP administrator can
add or remove users, or change the GSP configuration.
NOTE Before starting this procedure, you will need to know the following information:
• User's name
• Organization's name
• Login name
• User's password
To add a user, perform the following steps:
Step 1. Type +
ctrl b
Chapter
+ .
ctrl b
to access the GSP.
Configuring the Guardian Service Processor (GSP)
113