HP A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual page 73

Installing a Stand-alone Server in a Cabinet
Installing a Stand-alone Server in an HP Cabinet
The following information pertains to rp24xx server installation in cabinets manufactured by
Hewlett-Packard only.
Cabinet Identification
The following HP cabinets can hold multiple HP-9000 A-Class, rp24xx servers:
Cabinet Product No.
A4900A
A4901A
A4902A
A5134A (HPe3000)
A5135A (HPe3000)
A5136A (HPe3000)
J1502A
J1501A
J1500A
C2785A
C2786A
C2787A
Cabinet Loading Requirements
Servers require two EIA of cabinet space (each two EIA of space is equivalent to the height of a server).
Ensure that the cabinet has this amount of space available.
Fill empty cabinets from the top down. If you are mounting one or more servers into an empty cabinet, start
at the inside top of the cabinet and count down four of the holes in the columns at each corner to determine
the position of the rails for the first server. When the first rails are installed, continue to use the four hole
requirement as your guide for installing additional rp24xx servers.
Installing the Server
The following procedure describes how to install a stand-alone server into an approved cabinet on a slide-rail
assembly.
Step 1. Ensure that the anti-tip stabilizers or cabinet ballast are properly installed on the cabinet and
secured.
Chapter
Assembled by: Size (Height x Width)
Factory 1.25m x 19"
Factory 1.6m x 19"
Factory 2.0m x 19"
Factory 1.25m x 19"
Factory 1.6m x 19"
Factory 2.0m x 19"
Field 1.25m x 19"
Field 1.6m x 19"
Field 2.0m x 19"
Field 1.1m x 19"
Field 1.6m x 19"
Field 2.0m x 19"
Installing a Stand-alone Server in a Cabinet
Max. Servers
12
16
20
12
16
20
12
16
20
10
16
20
81