NEC iPASOLINK EX Advanced Installation Manual page 33

CONNECT CABLES
5.1 Overview
This section provides the descriptions for connecting Traffic Cables and Power
Cable. This section also provides the assembly procedures of the Grounding Cable
and Power cable for the purpose of preparing them on site, if needed.
Followings show the summary of the cable installation:
1. Connect the Grounding Cable to Grounding Terminal on iPASOLINK EX/A. (See
6. GROUND iPASOLINK EX/A
2. Connect the Power Cable.
3. Connect a LAN Cable to DCN (PoE) Port.
(1) Connect a LAN Cable to DCN (PoE) Port on iPASOLINK EX/A.
(2) Connect the other end of LAN Cable:
 To use this port as PoE, connect it to the power injector.
 To operate WebLCT , connect it to your PC (web browser should be
4. Connect LAN Cables to P2 , P3 and P4 Ports, as necessary.
iPASOLINK EX Advanced: I
NOTE: Tightening torque is 2.7 ±0.3 N•m
NOTE: This step is not required when using a PoE. Refer to
NOTE: To use this port as the PoE, confirm that the power injector to be
connected is powered off. If it is powered on, connecting the LAN
cable to DCN (PoE) port immediately turns on the iPASOLINK EX/A.
installed).
NSTALLATION
5. CONNECT CABLES
for detailed descriptions and steps.)
5-1
Step 3.
GGS-000546-13E