Troubleshooting
Adjusting Volume
You can change the volume of the fol-
lowing sounds the machine makes:
❖ On Hook
Sounds when you press the {On
Hook Dial} key.
❖ Transmission
Sounds when the machine sends a
message.
❖ Reception
4
Sounds when the machine receives
a message.
❖ Dialing
After pressing the {Start} key, this
sound is made until the line con-
nects to the destination.
❖ Key Tone
Sounds when keys on the Control
Panel are pressed.
❖ Alarm
Sounds as a warning.
Note
❒ When using On Hook Dial, you
can adjust the volume on the dis-
play by pressing the {On Hook Dial}
key. See p.49 "On Hook Dial", Ad-
vanced Features .
❒ You can assign the Monitor Vol-
ume function to a User Function
key. See p.101 "User Function
Keys", Advanced Features . When
you press the User Function key
with this function programmed in,
proceed to step F in the following
procedure.
❒ Make sure that the machine is in
standby mode before performing
the following procedure.
96
A
Press the {User Tools} key.
B
Press 0 or 1 until " 2. Fax Fea-
tures " is displayed.
C
Press the {OK} key.
Confirm that " 1. Program / Delete
" is displayed.
D
Press 0 or 1 until " 3. Setup " is
displayed.
E
Press the {OK} key.
Confirm that " 1. Monitor Volume
" is displayed.
ZHMS130E