Ricoh FAX4430NF Operating Instructions & Basic Features page 51

Limitation
❒ If the other party's machine does
not support the resolution at
which you are sending, this ma-
chine automatically switches to a
resolution which is supported.
This machine can send with Stan-
dard, Detail, Super Fine and Extra
Super Fine. Even if you send the
original with Extra Super Fine, the
other party's machine may receive
it with Fine (8x15.4 lines/mm, 200
x 4 0 0 d p i ) o r D e t a i l ( 8 x 7 . 7
lines/mm, 200 x 200 dpi).
❒ When copying or receiving with
Extra Super Fine, the optional
40MB memory card is required.
Turn on the "Ex. Super Fine" with
the User Parameters (switch 20; bit
1,3). See p.139 "User Parameters",
Advanced Features .
❒ When sending with Extra Super
Fine, turn on the "Ex. Super Fine"
with the User Parameters (switch
20, bit 2). See p.139 "User Parame-
ters", Advanced Features .
Note
❒ This machine can receive fax mes-
sages with Standard, Detail, Su-
per Fine, and Extra Super Fine
(optional).
❒ You can check the resolution type
with the Journal.
❒ When turning on the "Ex. Super
Fine" with the User Parameters
(switch 20; bit 2,3), sending or re-
ceiving faxes on multiple lines
may not be possible. Copies and
received documents may not be
printed either.
❒ To select 300 x 300 dpi, the NIC
FAX unit (Option for Type1) is re-
quired. 300 x 300 dpi can be used
with the scanner function. When
sending fax messages with 300 x
300 dpi, the machine switches to
Detail automatically.
❒ You can set the resolution type af-
ter the power is turned on or the
{Energy Saver/Clear Modes} key is
pressed with the User Parameters
(switch 00; bit 5,4). See p.139 "User
Parameters", Advanced Features .
A
Press the {Resolution} key to
switch between resolutions.
The indicators above the key show
the current selection.
Note
❒ When Detail and Super Fine
are lit at the same time, 300 x 300
dpi (optional) is selected.
Scan Settings
2
ZHMS190E
45