Ricoh FAX4430NF Operating Instructions & Basic Features page 30

Getting Started
10.
Add Toner indicator
Blinks when toner is low and lights con-
tinuously when toner has completely run
out. See p.92 "Replacing the Toner Car-
tridge".
1
11.
Load Paper indicator
Lights when a paper tray is empty or the
paper tray is not fully inserted.
12.
Receive File indicator
Lights when a message has been received
into memory.
13.
{Energy Saver/Clear Modes} key
• Energy Saver: Hold down this key for
about 2 seconds to manually enter En-
ergy Saver mode. The machine auto-
matically enters Energy Saver mode
about 5 minutes after the last opera-
tion is carried out. See p.203 "Energy
Saving", Advanced Features .
• Clear Modes: Cancel the current set-
tings and return to the standby mode
(except when accessing the User
Tools).
14. {Copy} key
Press to copy the originals currently load-
ed in the ADF.
15.
Quick Dial keys
Use to dial numbers with a single touch
or to enter letters and symbols. Also use
for the Group Dial function.
You can select from two types of key-
board layout: QWERTY (as shown in the
illustration) and ABCDEF. See p.155
"Key Layout", Advanced Features .
16.
Quick Dial Key Flip Plate
There are two Quick Dial Key Flip Plates.
• To access Quick Dials {01} to {30}, flip
both plates right.
• To access Quick Dials {31} to {60}, flip
one plate left.
• To access Quick Dials {61} to {90}, flip
both plates left.
Note
❒ Make sure the plate is flat against the
control panel when you use Quick
Dial keys.
24
17. {Stamp} key
Press this key to switch the Stamp func-
tion on. See p.53 "Stamp", Advanced Fea-
tures .
18.
Original Type key
• Color Scan (Only for Type2, and
Type1 with the optional NIC FAX
unit)
Select when scanning color originals
using the optional scanner function.
• Halftone
Select halftone when faxing or copy-
ing photographs or illustrations with
fine gradations. Also it can be used for
color originals.
19.
{Memory Trans.} key
Press this key to switch between Memory
Transmission and Immediate Transmis-
sion modes.
When the indicator is not lit, Immediate
Transmission is selected, and when the
indicator is lit, Memory Transmission is
selected.
20.
Resolution key
Press to select the level of detail (Stan-
dard, Detail, Super Fine, Extra Super Fine
or 300 dpi) to be sent. 300 dpi can be se-
lected only with the scanner function of
Type2 and Type1 with the optional NIC
FAX unit.
Note
❒ When receiving fax messages or copy-
ing with Extra Super Fine, the option-
al 40MB memory card is required.
❒ To select 300 dpi, the NIC FAX unit
(Option for Type1) is required.
ZHMS190E