Netstat; Synopsis; Ping; Setniccfg/Getniccfg - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

netstat

NOTE:
Table A-19 describes the netstat subcommand.
Table A-19. netstat
Subcommand
netstat

Synopsis

racadm netstat [< network interface number >]

ping

NOTE:
Configure DRAC 4 permission.
Table A-20 describes the ping subcommand.
Table A-20. ping
Subcommand
ping
Synopsis
racadm ping < ipaddress >

setniccfg/getniccfg

NOTE:
NOTE:
Table A-21 describes the setniccfg and getniccfg subcommands.
164
racadm Subcommand Man Pages
To use this command, you must have Execute Diagnostic Commands permission.
Definition
Prints the contents of the routing table. If the optional interface number is provided,
then netstat prints additional information regarding the traffic across the interface,
buffer usage, and other network interface information.
To use this command, you must have Execute Diagnostic Commands or
Definition
Verifies that the destination IP address is reachable from the DRAC 4 with the
current routing-table contents. A destination IP address is required. An ICMP echo
packet is sent to the destination IP address based on the current routing-table contents.
To use the setniccfg command, you must have Configure DRAC 4 permission.
To use the getniccfg command, you must have Log In To DRAC 4 permission.