Using The Racadm Cli; Racadm Command Description; Table 8-2. Racadm Command - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Table 8-1. Serial/Telnet Commands (continued)
Command
getsysinfo
serveraction
getraclog
clrraclog
gettracelog
getsel
clrsel
connect com1 or
connect com2
racadm

Using the racadm CLI

The racadm CLI commands can be run locally or remotely from the serial or telnet console
command prompt or through a normal DOS or Linux command prompt.
Use the racadm command to configure DRAC 4 properties, perform remote management tasks,
or recover a crashed system. Table 8-2 lists the racadm command that you can type into the
racadm CLI.
When using the racadm CLI, type racadm help to display the entire racadm subcommand
list, which lists all the commands supported by the DRAC 4. The following sections provide
information about how to use the racadm commands.
®
NOTE:
MS-DOS version 6.22 is required to use the DOS racadm command line feature. To limit DOS
racadm output to a single screen, use the MS-DOS more.com utility. Type the following command at the
prompt: a: racadm help | more

racadm Command Description

Table 8-2. racadm Command

Command
racadm
Without options, the racadm command executes the help command, which displays a list of
available commands and a one-line description of each. Type racadm help < subcommand >
to display any syntax and command line options for the < subcommand >.
Description
Displays general DRAC 4 and system information.
Executes a graceful hard server reset, or power-on, power-off, or power-cycle.
Displays DRAC 4 log entries.
Clears the DRAC 4 log entries.
Displays Trace Log entries.
Displays System Event Log entries.
Clears the System Event Log entries.
Connects the DRAC 4 to the system serial port.
Command line status and configuration utility for the DRAC 4.
.
Description
Command line status and configuration utility for the DRAC 4.
Using the serial and racadm Commands
129