Table 4-31. Drac 4 Log Messages - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Table 4-31. DRAC 4 Log Messages

Message ID
RAC186W
RAC188W
RAC189A
RAC191E
RAC198A
RAC199W
RAC256A
RAC257W
RAC258E
RAC016A
RAC030A
RAC048A
RAC049A
RAC064A
80
Managing and Recovering a Remote System
Description
DHCP: no response from server,
need LAN address. The NIC
cannot be enabled until a
response is received from the
DHCP server.
DHCP: no response from server,
warm starting with <IP address>.
Email page successful.
SNMP: internal failure during trap
generation.
SNMP: trap sent to <IP address>. Provides information only. No corrective
Email paging attempts failed,
SMTP protocol failure.
DRAC 4 hardware log event:
<formatted hardware log event>.
DRAC 4 log cleared.
DRAC 4 time was set.
DRAC 4 firmware update was
initiated.
DRAC 4 Firmware Update was
initiated with config to defaults
option.
Clear crash screen.
Suggested Action
Provides information only. No specific
corrective action is indicated. Ensure that the
DHCP server is operational.
Provides information only. No specific
corrective action is indicated. Ensure that the
DHCP server is operational.
Provides information only. No corrective
action is necessary.
Reset the DRAC 4 and retry the operation.
action is necessary.
A trace of the SMTP connection may be
found in the trace log. Examine the trace log
to identify the source of the protocol failure,
such as the connection could not be
established (SMTP server is down or an
invalid IP address), an invalid email
destination address, an invalid domain in the
email address, or the SMTP server does not
support forwarding email. Correct the
problem and try again.
Provides information only. No corrective
action is necessary, unless the contents of the
hardware log indicate a problem. In this case,
the corrective action is based on the
problem reported.
Provides information only.
Provides information only.
Provides information only.
Provides information only.
Provides information only.