Synopsis; Description For Setniccfg; Description For Getniccfg; Output - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Table A-21. setniccfg/getniccfg
Subcommand
setniccfg
getniccfg
NOTE:
The terms NIC and Ethernet management port may be used interchangeably.

Synopsis

racadm setniccfg -d
racadm setniccfg -s [< ipAddress > < netmask > < gateway >]
racadm setniccfg -o
racadm getniccfg

Description for setniccfg

The setniccfg subcommand sets the controller IP address.
• The -d option enables DHCP for the Ethernet management port (default is DHCP enabled).
• The -s option enables static IP settings. The IP address, netmask, and gateway can be
specified. Otherwise, the existing static settings are used.
• The -o option disables the Ethernet management port completely.
< ipAddress >, < netmask >, and < gateway > must be typed as dot-separated strings.

Description for getniccfg

The getniccfg subcommand displays the current Ethernet management port settings.

Output

The setniccfg subcommand returns without output if successful. The getniccfg subcommand
output displays the following information:
Network adapter = Enabled/Disabled
DHCP = Enabled/Disabled
Static IP Settings: < ipAddress > < netmask > < gateway >
Current IP Settings: < ipAddress > < netmask > < gateway >
Definition
Sets the IP configuration for the controller.
Displays the current IP configuration for the controller.
racadm Subcommand Man Pages
165