getractime
NOTE:
To use this command, you must have Log In DRAC 4 permission.
Table A-17 describes the getractime subcommand.
Table A-17. getractime
Subcommand
getractime
Synopsis
racadm getractime [-u] [-d]
Description
The getractime subcommand displays the time in one of the following two formats:
•
u — The UTC hexadecimal value followed by the offset in signed decimal (default).
•
d — The yyyymmddhhmmss.mmmmmms off string with no option is displayed in the same
format as the UNIX
Output
The getractime subcommand displays the output on one line.
ifconfig
NOTE:
To use this command, you must have Execute Diagnostic Commands or
Configure DRAC 4 permission.
Table A-18 describes the ifconfig subcommand.
Table A-18. ifconfig
Subcommand
ifconfig
Synopsis
racadm ifconfig
Definition
Displays the time from the controller.
®
date command.
Definition
Displays the contents of the network interface table.
racadm Subcommand Man Pages
163
Need help?
Do you have a question about the Remote Access Controller 4 Firmware Version 1.30 and is the answer not in the manual?
Questions and answers