Remote Management Access - Dell PowerConnect 3324 User Manual

**************************************************
*****************
**************************************************
.
.
.
.

Remote Management Access

To allow remote device management (Telnet, Web etc.) perform the following:
Enter the command enable at the console to enter the Privileged EXEC screen mode
1
as follows:
console>enable
console#
Connect the management station (PC) to the device via one of the Ethernet ports (or
2
via a network connected to the device) using a CAT5 Cable, to port e1 in this example.
Ensure (on the ASCII terminal) that the interface status changed to "up" and that the
STP status is forwarding (after 30 seconds):
console>enable
Console#
01-Jan-2000 01:43:03 %LINK-I-Up:
01-Jan-2000 01:43:03 %LINK-I-Up:
01-Jan-2000 01:43:34 %STP-I-PORTSTATUS: Port 1/e1: STP status
Forwarding
Enter the command configure at the console to enter the Configuration screen mode
3
as follows:
console> enable
console# configure
console(config)#
SYSTEM RESET *****************
C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
Vlan 1
1/e1
65