Switching Port Default Settings - Dell PowerConnect 3324 User Manual

Switching Port Default Settings

The following table describes the Port default settings.
P o r t D e f a u l t S e t t i n g s
Function
Port speed and mode
Port forwarding state
Port tagging
Head of line blocking prevention
Flow Control
Back Pressure
The following is an example for changing the port speed on port 1/e5 using CLI
commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# speed 100
The following is an example for enabling flow control on port 1/e5 using CLI commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# flowcontrol on
The following is an example for enabling back pressure on port 1/e5 using CLI commands:
console> enable
console# configure
Console (config)# interface ethernet 1/e5
Console (config-if)# back-pressure
44 C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
Default Setting
10/100M copper ports: auto-negotiation
1000M auto-negotiation
Enabled
No tagging
On (Enabled)
Off
Off