Management Access On Stacks - Dell S4048–ON Configuration Manual

Auto reboot Stack-unit:
Auto failover limit:
-- Stack-unit Failover Record
------------------------------------------------
Failover Count:
Last failover timestamp:
Last failover Reason:
Last failover type:
-- Last Data Block Sync Record:
------------------------------------------------
stack-unit Config:
Start-up Config:
Runtime Event Log:
Running Config:
ACL Mgr:
LACP:
STP:
SPAN:

Management Access on Stacks

You can access the stack via the console port or VTY line.
• Console access — You may access the stack through the console port of the master unit (stack manager) only. Similar to a standby
RPM, the console port of the standby unit does not provide management capability; only a limited number of commands are available.
Member units provide a limited set of commands.
• Remote access — You may access the master unit and standby unit in a stack through the dedicated management Ethernet interfaces
with SNMP, SSH, or via Telnet.
Example of Accessing Non-Master Units on a Stack via the Console Port
-----------------CONSOLE ACCESS ON A STANDBY----------------------------
Dell(standby)#?
cd
clear
copy
delete
dir
disable
enable
exit
format
fsck
pwd
rename
reset
show
ssh-peer-stack-unit
start
telnet-peer-stack-unit
terminal
upload
Dell(standby)#
-----------------CONSOLE ACCESS ON A MEMBER----------------------------
Dell(stack-member-1)#?
reset-self Reset this unit alone
show Show running system information
You can connect two units with two or more stacking cables in case of a stacking port or cable failure. Removal of only one of the cables
does not trigger a reset.
Disabled
3 times in 60 minutes
--
0
None
None
None
--
succeeded Nov 25 2014 15:29:58
succeeded Nov 25 2014 15:29:58
succeeded Nov 25 2014 15:29:58
succeeded Nov 25 2014 15:29:58
succeeded Nov 25 2014 15:29:58
no block sync done
no block sync done
no block sync done
Change current directory
Reset functions
Copy from one file to another
Delete a file
List files on a filesystem
Turn off privileged commands
Turn on privileged commands
Exit from the EXEC
Format a filesystem
Filesystem check utility
Display current working directory
Rename a file
Reset selected card
Show running system information
Open a SSH connection to the peer stack-unit
Start shell
Open a telnet connection to the peer stack-unit
Set terminal line parameters
Upload file
Stacking 901