The following fields set the RADIUS default values:
•
Default Timeout for Reply (1-30)—Specifies the default amount of time (in seconds)
the device waits for an answer from the RADIUS server before timing out.
NOTE: If Host Specific Timeouts, Retransmit, Dead Time, or Deny values are not specified, the
Global values are applied to each host.
•
Default Retries (1-10)—Specifies the default number of transmitted requests sent to
RADIUS server before a failure occurs.
•
Default Dead time (0-2000)—Specifies the default amount of time (in seconds) that
a RADIUS server is bypassed for service requests. The range is 0-2000.
•
Default Key String (1-16 Characters)—Indicates the Default Key string used for
authenticating and encrypting all RADIUS communications between the device and
the RADIUS server. This key is encrypted.
•
Source IP Address—Indicates the default IP Address for the device accessing the
RADIUS server.
Defining RADIUS Parameters:
Open the RADIUS Settings page.
1
Define the Default Timeout for Reply, Default Retries, Default Dead Time, and
2
Default Key Strings fields.
Click Apply Changes. The RADIUS settings are updated to the device.
3
Adding a RADIUS Server:
Open the RADIUS Settings page.
1
Click Add. The Add RADIUS Settings page opens:
2
A d d R A D I U S S e r v e r P a g e
C o n f i g u r i n g S y s t e m I n f o r ma t i o n
165