Removing A Hard Drive From A Hard-Drive Carrier; Installing A Hard Drive Into A Hard-Drive Carrier - Dell PowerEdge T610 Hardware Owner's Manual

Figure 3-5. Installing a Hot-Swap Hard Drive
1
2
1 release button
3 Install the hot-swap hard drive.
Press the button on the front of the drive carrier and open the handle.
a
Insert the hard-drive carrier into the drive bay until the carrier
b
contacts the backplane.
Close the handle to lock the drive in place.
c
4 Replace the front bezel. See "Installing the Front Bezel."

Removing a Hard Drive From a Hard-Drive Carrier

Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.

Installing a Hard Drive Into a Hard-Drive Carrier

1 Insert the hard drive into the hard-drive carrier with the connector end
of the drive at the back. See Figure 3-6.
2 Align the screw holes on the hard drive with the back set of holes on the
hard-drive carrier.
86
Installing System Components
2 hard drive carrier handle