Dell PowerEdge T610 Hardware Owner's Manual page 28

Table 1-1. LCD Status Messages (continued)
Code Text
CPU # temp
E1414
exceeding
range. Check
CPU heatsink.
E1418 CPU # not
detected.
Check CPU is
seated
properly.
E141C Unsupported
CPU
configuration.
Check CPU or
BIOS revision.
E141F CPU # protocol
error. Power
cycle AC.
E1420 CPU Bus parity
error. Power
cycle AC.
CPU # machine
E1422
check error.
Power cycle
AC.
28
About Your System
Causes
Specified processor is out
of acceptable temperature
range.
Specified processor is
missing or bad, and the
system is in an
unsupported
configuration.
Processors are in an
unsupported
configuration.
The system BIOS has
reported a processor
protocol error.
The system BIOS has
reported a processor bus
parity error.
The system BIOS has
reported a machine check
error.
Corrective Actions
Ensure that the processor
heat sinks are properly
installed. See
"Troubleshooting the
Processor(s)" and
"Troubleshooting System
Cooling Problems."
Ensure that the specified
microprocessor is
properly installed. See
"Troubleshooting the
Processor(s)."
Ensure that your
processors match and
conform to the type
described in the processor
technical specifications
outlined in your system's
Getting Started Guide.
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."